







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why Santa Rosa Homeowners Choose Toto Construction
Barrett & Sons Construction Santa Rosa provides independent Toto service and installation across Sonoma County: bathroom remodels that keep or replace Drake and Ultramax II toilets, walk-in showers fed by Toto thermostatic valves, and tile work set around Washlet-equipped layouts. We’re an independent Toto service provider. We are not affiliated with, authorized by, or endorsed by Toto, and we don’t handle manufacturer warranty claims. What we do is work with Toto fixtures every week in Santa Rosa, know how they fail, and install or replace them to code with permits pulled and inspections signed. Call (866) 864-4083 for a free estimate.
Why Trust Barrett & Sons Construction Santa Rosa for Your Toto Construction?

Our crew members have up to 28 years of experience, and the ones who work on Toto fixtures know the difference between a 528T-style fill valve and a generic one that fits but changes everything about how the toilet refills. That matters here. Toto’s quiet-close and refill timing are tuned to specific parts, and cutting corners on them is how a quiet bathroom starts gurgling at night.
We source genuine Toto replacement fill valves, flappers, gaskets and Washlet filters for models still in support. Where Toto has discontinued a part, we quote a quality aftermarket option and say plainly that it’s aftermarket. No pretending. No swapping in a no-name valve and calling it OEM.
Warranty-safe practice is part of the job: we document what we touch, keep the original hardware when it’s still good, and hand you a written record so your Toto coverage stays intact wherever it applies. Every eligible Santa Rosa bathroom job gets permits pulled and inspections signed, and every completed job is backed by the written 90-Day Done Right Promise. Tom Barrett publishes his name, address and license number – look it up before you sign anything.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Common Toto Construction Problems We Fix in Santa Rosa
Santa Rosa’s hard water and dry summers leave their mark on Toto fixtures, and these are the failures we see most. The symptoms below come from scale, mineral deposits and normal wear – not from one-off defects.
- Drake and Ultramax II toilets refilling every few minutes. A worn fill-valve diaphragm, usually a 528T-style valve, or a distorted tank-to-bowl gasket is the culprit. You’ll hear a faint water sound at night and see the bowl refill on its own. Scale from hard water accelerates diaphragm wear, and it’s the most common Toto repair call in Santa Rosa we get.
- Washlet C100/C200 and S350e seats losing spray pressure. Hard-water deposits clog the inlet filter and nozzles, so the spray weakens or the warm-water flow drops off. A clogged filter is usually a clean-and-replace fix; a failed control board on a seat past eight or ten years old is a different math.
- Toto thermostatic shower valve cartridges sticking. Temperature drifts or the handle resists when the cartridge has scaled up. On Thermostatic Mixing Valve trims, mineral buildup in the cartridge body is the usual cause – not a valve that “went bad overnight.”
- EcoPower and EcoVessel sensor flush valves trickling or not flushing. The flush tower seal and chain wear, and sensor battery or solenoid wear causes no-flush or constant trickle. These commercial-grade valves need the right seal and a sensor that’s actually reading, or you’re guessing.
- Wood-shake and redwood-era bathrooms with outdated plumbing behind Toto fixtures. In Coffey Park and Fountaingrove rebuild homes, the fixtures are new but the supply lines and angle stops sometimes aren’t. When we set a Toto toilet or shower valve, we check what’s feeding it.
Toto Parts & Our Repair-vs-Replace Approach

Genuine Toto parts matter on these fixtures more than people expect. A no-name fill valve may thread in fine, but it often changes refill timing and can wipe out the quiet-close advantage you bought the toilet for. We use genuine Toto fill valves, flappers, gaskets and Washlet filters wherever the model is still supported, and we’re honest when a part is discontinued and the best option is quality aftermarket.
We don’t claim to stock parts locally – we source the right part for your model, so there’s no mystery-brand substitutions off a shelf. On repair versus replace: if a one-piece Ultramax II needs a tank-to-bowl separation, or a Washlet seat at eight to ten years has a failed control board, honest advice is usually replacement. A $200 repair against a failing seat isn’t money well spent, and we’ll tell you so. Call (866) 864-4083 and we’ll give you a straight answer and a free estimate.
Our Toto Service Process – Step by Step
- 1
Diagnosis. We identify the exact model – Drake, Drake II, Ultramax II, Washlet C100/C200 or S350e, EcoPower/EcoVessel – because the part numbers and failure modes differ. We test for silent leaks, scale buildup and valve wear, not just the symptom you called about.
- 2
Written scope and repair-or-replace call. You get the diagnosis in writing, the parts we’ll use (genuine Toto or specified aftermarket), and a clear recommendation with the price. Any scope change arrives as a written change order before work starts.
- 3
Repair or installation. Fill valves, gaskets and flappers get genuine Toto parts where supported. Shower valve cartridges and sensor flush valves get proper seals and correct adjustment. In a remodel, the fixture work is sequenced with tile and shower so nothing gets set twice.
- 4
Test. We run the toilet through full cycles to confirm no phantom refill, check water level and flapper seal, verify Washlet spray and temperature, and confirm thermostatic valves hold temperature.
- 5
Warranty and record. Documentation of what was replaced, backed by the written 90-Day Done Right Promise. If something’s not right, one call brings Tom back.
See the difference
Before
After
Before
After
Before
AfterToto Products We Service & Install in Santa Rosa
We work on the Toto lines Santa Rosa homeowners actually have: Drake and Drake II two-piece toilets, Ultramax II one-piece toilets, Washlet C100/C200 and S350e bidet seats, and EcoPower and EcoVessel sensor faucets and flush valves. We also install them fresh in bathroom remodels, walk-in shower builds and tub-to-shower conversions, and set the tile and fixtures around them. If your model isn’t listed, call and describe it – most Toto residential fixtures are within what our crew handles. We source the right part for your model rather than promising shelf stock.
We Also Service These Brands
Toto is one line we work with, not the only one. We install and service KraftMaid cabinetry, Kohler fixtures, GAF roofing and PGT windows across Santa Rosa, so a bathroom or kitchen project that mixes brands is handled under one written scope. That means one crew coordinating Toto fixtures with Kohler valves and KraftMaid vanities, no finger-pointing between trades when something doesn’t line up.
FAQs – Toto Construction Service in Santa Rosa

Is Barrett & Sons Construction Santa Rosa authorized by Toto? No. We’re an independent Toto service provider and are not affiliated with, authorized by, or endorsed by Toto, and we don’t process manufacturer warranty claims. We install and service Toto fixtures using genuine Toto parts where supported and stand behind our work with the 90-Day Done Right Promise. Call (866) 864-4083 for a free estimate.
Do you use genuine Toto/OEM parts? Yes, wherever the model is still supported. We use genuine Toto replacement fill valves, flappers, gaskets and Washlet filters, and label anything aftermarket clearly when a Toto part is discontinued. Call (866) 864-4083 and we’ll tell you what your model needs.
How long does Toto service take? Most single-fixture repairs – a fill valve, gasket or flapper – are done in one visit. Washlet filter and nozzle cleaning, thermostatic valve cartridge replacement or a sensor flush valve typically run one to two hours. A remodel that includes Toto fixtures runs with the project schedule. Call (866) 864-4083 to talk through timing and get a free estimate.
What Toto models/series do you cover? Drake and Drake II, Ultramax II, Washlet C100/C200 and S350e bidet seats, and EcoPower and EcoVessel sensor faucets and flush valves, plus the tile and shower work around them. Call (866) 864-4083 if you’re unsure about your model.
Will service void my Toto warranty? Proper service using genuine Toto parts generally keeps coverage intact, but warranty terms are Toto’s to set, not ours. We document what we replace so you have a record. Call (866) 864-4083 to schedule a free estimate.
How much does Toto construction cost in Santa Rosa? Costs depend on the work. A single Toto toilet repair is a small job; a bathroom remodel that includes Toto fixtures runs higher. Here are our Santa Rosa ranges:
| Service | Price Range |
|---|---|
| Bathroom Remodel | $9,000 – $28,000 |
| Small Bathroom Remodel | $5,000 – $12,000 |
| Walk-In Shower Installation | $4,500 – $12,000 |
| Tub-to-Shower Conversion | $3,500 – $10,000 |
| Bathroom Vanity Installation | $800 – $3,000 |
Call (866) 864-4083 for an exact quote – estimates are free.
Book Your Toto Service in Santa Rosa, CA
Whether it’s a Drake toilet refilling every 20 minutes, a Washlet that’s lost its spray, or a full bathroom remodel built around Toto fixtures, we’ll diagnose it honestly and put the scope in writing before work starts. Our crew members have up to 28 years of experience, every eligible job gets permits pulled and inspections signed, and every completed job is backed by the written 90-Day Done Right Promise. Call (866) 864-4083 for a free estimate in Santa Rosa.
Written by the team at Barrett & Sons Construction Santa Rosa.












